Mail Archive Search: <+from:K8ZE@comcast.net>

Results:

References: [ +from:K8ZE@comcast.net: 6 ]

Total 6 documents matching your query.

1. [Amps] Some Suggestions Please (score: 1): Author: K8ZE@comcast.net (Mike Switzer); Date: Thu, 16 Jan 2003 22:35:08 -0500; Hi All I am going to a swap this weekend. I will be looking for some wire to wind the plate choke in my new project. What should I use? I have always used Teflon coated wire in the past, because it w; /archives//html/Amps/2003-01/msg00135.html (6,974 bytes)
2. [Amps] The wire question (score: 1): Author: K8ZE@comcast.net (Mike Switzer); Date: Fri, 17 Jan 2003 12:17:09 -0500; More specific on the wire question. I have seen references to magnet wire on this reflector. Why magnet wire? The commercial chokes I have seen were covered in cloth. That last one most likely dated; /archives//html/Amps/2003-01/msg00142.html (6,453 bytes)
3. [Amps] relay rattings (score: 1): Author: K8ZE@comcast.net (Mike Switzer); Date: Fri, 17 Jan 2003 13:53:18 -0500; On the subject of self-resonance. I had the occasion to observe one self-destruct before my very eyes. Unfortunately it was my amp and it was a couple or hours before the contest started. So my plan; /archives//html/Amps/2003-01/msg00144.html (7,365 bytes)
4. [Amps] K8CPA (score: 1): Author: K8ZE@comcast.net (Mike Switzer); Date: Thu, 26 Dec 2002 09:07:01 -0500; I am sorry if I seem a little naive but what is your point Chuck? I have been a ham for a little more than 24 hrs and have had quite a few rigs. I have in the past owned Ten Tec transceivers and been; /archives//html/Amps/2002-12/msg00295.html (7,835 bytes)
5. [Amps] (no subject) (score: 1): Author: K8ZE@comcast.net (Mike Switzer); Date: Thu, 26 Dec 2002 13:12:15 -0500; I need some opinions from you experts. I have been modifying a Drake L7. I have replaced the HV caps, removed old diodes/xistors and installed meter protection diodes per Mr. Measures's instructions.; /archives//html/Amps/2002-12/msg00296.html (9,137 bytes)
6. [Amps] Thanks All (score: 1): Author: K8ZE@comcast.net (Mike Switzer); Date: Sun, 29 Dec 2002 14:57:34 -0500; I have no idea what is/was wrong. I looked it over and could not see anything so I tried it one more time. It of course worked fine. I removed the tank coil so I could get at the band switch. All of; /archives//html/Amps/2002-12/msg00316.html (6,539 bytes)

Current List: 1 - 6
Page: [1]