>I have a relatively older FT1000D that seems to have dirty contacts
>somewhere. It is sometimes intermittent on receive (received goes quiet by
>3-5 S units) and can be temporarily fixed by cycling from receive to
>transmit and back. I am using the built-in relay (not QSK). Has anyone had
>any experience with cleaning this relay?
>73 Steve AA4V
Try using the RX antenna port when this problem occurs. If you get normal
operation there, I vote for the small reed relay on the LPF Board. There is a
higher voltage rated part available and I think that this replacement was
published as an upgrade/mod. by Yaesu as well. I lost mine in a "wiring
accident" and a friend lost his due to lightning (nearby) on his beverage
antenna. These were catastrophic failures though. The receiver was dead,
except via the RX antenna port. It's a fairly easy repair and under $20 for
the parts and shipping. GL.
73, Mark
--
FAQ on WWW: http://www.qsl.net/k7on/yaesu.html
Submissions: yaesu@contesting.com
Administrative requests: yaesu-REQUEST@contesting.com
Problems: owner-yaesu@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|