I have a Yaesu FT100D which I bought used recently, in the 2K serial number
range. It has the factory grounding-HI SWR mod done to it, and works fine
on 10 and 12m as a result. However, it has recently started to show a
problem with self oscillation on 70cm. It will show a HI SWR reading on SSB
and CW, but not on FM or AM for UHF. This probably started about 3 weeks
after getting it in. I opened up the case and tightened all of the circuit
board screws, and that helped for a couple of days. This past week the HI
SWR reading wasn't occurring much until today, when it is now occurring all
of the time.
I have looked at the previous messages on this topic from the ft100
reflector, but am still a little confused on how to fix this. As I stated,
the grounding mod was done at the factory, so that shouldn't be a problem.
Any other ideas as to how to fix this? I bought it from Burghardt's about
30 days ago and it has 60 days left on the warranty so hopefully they can
either fix it (if I can't do it myself) or exchange it. Just looking for
ideas as to where to start on this job myself.
73s John AA5JG
(ex: W5TD, NE0P)
6M WAS #1275, 6m VUCC #1260
2m VUCC #615, Satellite VUCC #129
_______________________________________________
Yaesu mailing list
Yaesu@contesting.com
http://lists.contesting.com/mailman/listinfo/yaesu
|