I had the same problem with an Iambic keyer from them. Come to find out
that they
had put way too much powder paint on the base. I couldn't get a good ground
connection through all the paint. Problem solved with a little scraping and
some
good star washers placed where there were no washers before.
Dave WA0ZZG
----- Original Message -----
From: "KZ2G" <kz2g@optonline.net>
To: "YAESU LIST" <YAESU@contesting.com>; "Ten-Tec @ Contesting. Com"
<tentec@contesting.com>
Sent: Monday, April 08, 2002 7:11 AM
Subject: [Yaesu] VibroPlex Code Warrior Jr. problems
> I occasionally have a problem with my VibroPlex Code Warrior Jr. iambic
> paddles. When I use it as a "squeeze key," squeezing the paddles
together,
> it does not send the -.-.-.-.- but just stops sending. I checked wiring
> and it is fine. and yet at times the "squeeze-key" works and then does
not
> work. my bencher paddles work fine on my Yaesu and Omni 6+ and on my MFJ
> electronic keyer.
>
> I thought the ground or another contact on the paddles was bad, shorted,
> cold soldered, etc. nope. I resoldered, I checked the connections.
spent
> 3 hours trying to get the paddles to work when squeezed as a "squeeze key"
> again. NOOOOO LUCK! Ultimately, I had to put the ground contact on one
> paddle, by the magnet. there it works fine as a "squeeze key," giving me
> true iambic function. yet it did work fine as a "squeeze key" once with
the
> ground wire on the base of the key where VibroPlex tells u to put it.
have
> any of u had this problem? I'm wondering if the paint on the base of the
> key paddles occasionally acts as an insulator. Weird.
>
> Bob, KZ2G --- 10-10 # 10148
> ----------------------------
> Omni 6 Plus & FT-100D, C U on CW!
> See my Ham web at http://www.geocities.com/ram9872002/kz2g.htm
> Check out my Art Sale at
http://www.geocities.com/ram9872002/Artpage1.htm
>
> _______________________________________________
> Yaesu mailing list
> Yaesu@contesting.com
> http://lists.contesting.com/mailman/listinfo/yaesu
>
|