Since I used %Z messages in NAQP RTTY, I looked at my set up. Here is what
I had to do to get it to work - I just tried it - works on CW for me.
You need to use %ZA1 & %ZA2 - where "A" is the network identifier of your
computer - remember, it was originally intended for networked operations.
Then select "register to accept network connections" under "setup" -
specify "A" for your computer.
Good luck.
Bob
W0BR
> Date: Fri, 3 Aug 2007 13:47:10 -0500
> From: "Nicholas Roy Smith" <nicksmith@citlink.net>
> Subject: [WriteLog] %Z
> To: <writelog@contesting.com>
> Message-ID: <000601c7d5fe$b46759b0$b67ed7aa@nickone>
> Content-Type: text/plain; charset="iso-8859-1"
>
> I cannot get %Z to work at all. The first time I put it in the buffer I
> did get a "1Z" but no frequency. Now after trying everything I can think of
> I cannot get any print for that command.
> I am using two radios on one computer, so shouldn't that be the command
> "%Z2" or %Z1" which ever radio frequency I want to send for the move?
>
> Help?
> Nick - W4GKM
>
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|