Hi Jamie,
I've added a bunch of specific WriteLog.ini entries in the 'Setting up You'
WriteLog.ini Settings section of my web site. This is one of them. From the
site:
"WriteLog, by default, sends at least two letters of a corrected call when
the + key is pressed (which logs the call and sends the 'QRZ' message). Some
people like sending the full call again signifying the correction rather
than just the partial call. This can be addressed in the Writelog.ini file
in the [Configuration] section.?
Partial Call:
CwSendPartialCallCorrections=0 (where 0 is zero)
Full Call:
CwSendPartialCallCorrections=1"
Also, the correct setup on the QSO B4 is to establish your normal exchange
message with the QSO B4 message enclosed in %B. For example, in CQ WW CW:
%C %BQSO B4%B5NN5
This would send the call and the 5NN5 exchange for signal report and zone.
Since it would check the call for a dupe, if the station worked was a dupe,
it would send the call and then the message between the %B's, in this case
K9JY QSO B4.
Hope this helps.
CU...Scot, K9JY
K9JY's WriteLog User Support Site at:
http://www.k9jy.com
mailto:scot@k9jy.com
> -----Original Message-----
> From: writelog-admin@contesting.com
> [mailto:writelog-admin@contesting.com]On Behalf Of Jamie WW3S
> Sent: Saturday, December 08, 2001 02:25 PM
> To: WriteLog
> Subject: [WriteLog] sending corrected call
>
>
> Is there a way to send the full call if its been corrected after
> sending the
> exchange? Currently my setup is just sending the suffix. Also
> whats the best
> way to setup a QSO B4 message? I guess I just don't get the %b
> setup.....(please no debate abt working/not working dupes; just
> the correct
> way to send a qso b4 message.tnx)
>
> 73 Jamie WW3S
>
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
|