WriteLog
[Top] [All Lists]

[WriteLog] CW keydown on Writelog com port

To: "Writelog" <writelog@contesting.com>
Subject: [WriteLog] CW keydown on Writelog com port
From: "Don Cassel" <doncassel@compuserve.com>
Date: Wed, 17 Sep 2003 08:58:33 -0400
List-post: <mailto:writelog@contesting.com>
I'm sure this is not a new problem but I can't seem to find it on the
reflector.

After having to do a new install of Win 98Se on a PIII 450 and a new install
of Writelog 10.40 (updated to 10.42C) I am experiencing a keydown situation
when selecting com1 for CW in Setup, Ports. CW keying is on com1 and rig
control for the Yaesu Mark V on com2. Rig control works okay. To rule out
any hardware problems I also reinstalled DX4Win and it works properly with
the same com ports. I am using Rigblaster Plus for the interface. This
configuration worked okay before with the same computer so some setting(s)
must be messed up but after spending several days on this I am beginning to
go in circles. Any suggestions would be much appreciated.

I have included my [Ports] section from Writelog.ini below.

Thanks, Don VE3XD (VE3BUC)

[Ports]
COM1:=9600,n,8,1,x
COM2:=9600,n,8,1,x
dvktype=2
dvkport=0
cwtype=1
cwport=1
dvkstoploop=1
dvkechomic=1
LPT1=0x378
LPT2=0x0
LPT3=0x0
CWPTTCONTROL=1
CWPTTDELAY=0
CW_ON_PIN1=1
CommSlot1=1
Comm2Used=USED,POLL,18
Comm2RigManager={D0DE9422-0517-11D4-9D1B-00105AA43DDF}
Comm2XmitControl=ALWAYS
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web:  http://www.writelog.com/

<Prev in Thread] Current Thread [Next in Thread>
  • [WriteLog] CW keydown on Writelog com port, Don Cassel <=