I have driven the band decoders from LPT ports successfully in the
past. Was hoping I could use the LPT port on the MK2R+ to do the
same. Doesn't appear to support band info on that port. Anyone able
to make it work on the Acc port? I assume this would require me to
make a custom cable?
MK2R+ LPT port is an input. If you want to drive a band decoder from
MK2R+ use the ACC port a described on pages 60-62 of the MK2R Users
Manual. Band Data is available from three sources - "Band Map" derived
from the CAT data for each radio, a copy of data on the LPT input, or
"Antenna Relay" data from Writelog (set by protocol commands).
> I assume this would require me to make a custom cable?
The required cable is simply pins 6-9 and ground (Radio 1) or 10-13
and ground (Radio 2).
However, since MK2R+ only uses FSK and PTT on the K3 ACC port, you can
also use the Elecraft E980190 "Y" cable (also available from Cables
Wholesale and Altex) to connect both the band decoder and MK2R+ to the
K3.
73,
... Joe, W4TV
On 2014-12-07 5:07 AM, Randy Thompson K5ZD wrote:
I am using Writelog and the Microham MK2R+ SO2R controller with a pair of
K3s. The MK2R+ is consuming the Acc port on the K3. I would like to drive
my Top Ten Band Decoder from the MK2R+.
I have driven the band decoders from LPT ports successfully in the past.
Was hoping I could use the LPT port on the MK2R+ to do the same. Doesn't
appear to support band info on that port. Anyone able to make it work on
the Acc port? I assume this would require me to make a custom cable?
Thanks.
Randy, K5ZD
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|