I haven't noticed losing the filter settings on the 1000-D, however, I did
notice that if you've got a TX or RX Clarifier (RIT/XIT) set to on, and
click on a spot, it disables it.
I use FSK on a 1000D, and always go through the bands and turn on all RIT's
and reset them to 0.00, and then have them ready. If you click on a spot in
the bandmap, the RIT is turned off, and you find yourself turning the
clarifier knob and it not doing anything. After noticing this, I just
always make a note to turn it back on if you ever click on something in the
bandmap. Never thought to ask anyone about this until now.
Charlie
KI5XP
> -----Original Message-----
> From: writelog-bounces@contesting.com
> [mailto:writelog-bounces@contesting.com]On Behalf Of George Skoubis
> Sent: Sunday, November 28, 2004 8:15 PM
> To: writelog@contesting.com
> Subject: RE: [WriteLog] Filter Reset by Clicking Spot
>
>
> Hi,
>
> We had this discussion a few months ago (it may have been on the
> TenTec or Orion reflectors). The Orion allows you to set the "default"
> DSP bandwidth in each mode.
>
> A. Set your DSP bandwidth to the width you prefer using the BW knob.
>
> B. Press the mode button.
>
> C. Choose a different mode.
>
> D. Press the mode button and return to the original mode.
>
> The bandwidth you set is now the default bandwidth.
>
> Do this for each mode and change as often as you wish... I used
> Writelog and an Orion this weekend and operated Assisted so I know it
> works FB...
>
> 73,
>
> George / KF9YR
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|