Not sure what benefit RUN and S&P provides in N1MM, I am sure somebody
does, but means nothing to me.
I just use my macro key assignments to dictate RUN and S&P.
F2-F3- F4 for RUN
F5 - F6 for S&P
Yes you can setup ENTER Sends Exchange in WL. Just assign the proper
Macro Key assignments in your WL.ini file
Example of mine:
Put these with the F key assignments of your liking in the
[Configuration] section
SendCallExchangeKey=3
QrzFunctionKey=4
CqFunctionKey=2
Note: I prefer to use the F1 as my "AGN" or "?" key. So F2 is my CQ,
F3 Exchange, F4 QRZ
On 4/6/2026 2:59 PM, Mark Griffin wrote:
Normally with N1MM you can designate whether you wish to run or use S&P. Of
course when running you normally hit the enter key and your transceiver
calls CQ. When someone responds to your CQ you enter their callsign and hit
enter and your transceiver sends the exchange. Once that is done they give
you their exchange and you hit enter and your transceiver sends TU and QRZ.
And then the process of calling CQ starts all over again. I see that there
are S&P memories, but don't see anything specific with regards to running.
Can anyone assist me with this?
Mark Griffin, KB3Z
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|