Try turning off "Transceiver Mode" in the comm port settings on the radio.
Mike, W1NR
----- Original Message -----
From: "miles" <miles@milarasmt.com>
To: <writelog@contesting.com>
Sent: Tuesday, June 27, 2006 7:51 AM
Subject: [WriteLog] Anyone using FT9000 with Writelog?
>
> Here are some issues that I have.
> Has anyone else seen similar.
> Thanks,
> Miles
>
>
> Serial drop
>
> At any baud rate, the serial link between writelog and the Ft9000 drops
> "No
> Radio" shows up on the display.
>
> I have tried all baud rates from 4800 - 9600.
>
> The cable is a stock 9 pin serial.
>
> The link only stays up for a short time then drops.
>
>
>
> Split light.
>
> Frequency when changing frequency by clicking on Spots or the Freq GUI
> bars,
> the Split light on the 9000 keeps coming on.
>
> I keep manually shutting off split, but it keeps coming back on.
>
>
>
> Freq Gui bars.
>
> When I click on a vfo gui bar, it will load the freq into the Primary
> display.
>
> Is there any way to use these as just a way toggle between the two a/b
> vfo's.
>
> If VFO A is the primary and I click on the gui for vfo B, it will load VFO
> A
> with the values from the gui B.
>
> I end up with both vfo A and B the same freq. What I would prefer is to
> click on Gui A to become the primary or click B to become the primary,
> not
> rewrite the primary, just toggle between the two.
>
>
>
>
>
> Any input will be helpful full
>
> Thanks, Miles
>
> om/
>
> _______________________________________________
> WriteLog mailing list
> WriteLog@contesting.com
> http://lists.contesting.com/mailman/listinfo/writelog
> WriteLog on the web: http://www.writelog.com/
>
_______________________________________________
WriteLog mailing list
WriteLog@contesting.com
http://lists.contesting.com/mailman/listinfo/writelog
WriteLog on the web: http://www.writelog.com/
|