What else is powered in the RF deck without PTT enabled? If this is ONLY
the pallet current it should draw nothing until PTT is enabled.
1 Amp with PTT no RF is correct.
I suspect you're measuring something else too.
73
Fred
K1FMS
On Sun, Jun 29, 2025, 10:46 AM David R Buckwalter via VHFcontesting <
vhfcontesting@contesting.com> wrote:
>
>
>
>
> What should I see for device DC current on the Gemini 70-1K amplifier? I
> replaced the Ampleon ART1K6FH device due to failure. With the new device
> installed the DC supply to the RF deck draws 1 amp powered on at idle.
> When
> PTT is engaged the current rises to 2 amps. In an earlier conversation
> with Roger at the DX Shop implied 1 amp Idq was what I should see. The 2
> amp reading seems high to me, but with no technical documentation on this
> amp, I have nothing to base it on. There is an adjustment on the RF deck
> that is most likely for setting Idq. Should I set this back to 1 amp with
> PTT and no RF drive?
>
>
>
>
>
> K3SK
>
> _______________________________________________
> VHFcontesting mailing list
> VHFcontesting@contesting.com
> http://lists.contesting.com/mailman/listinfo/vhfcontesting
>
_______________________________________________
VHFcontesting mailing list
VHFcontesting@contesting.com
http://lists.contesting.com/mailman/listinfo/vhfcontesting
|