Hello group,
I have a bit of a problem. I have an HTX10 that I modified for transverter use
quite awhile ago. The transverter I was using at the time used a split TX and
RX line. Now, I just bought a transverter that uses a common TX/RX line...
So, I need to re-combine the TX/RX line. You can find the mod I used here:
http://pages.cs.wisc.edu/~timc/e/htx-10.html
I'm pretty good with a soldering iron and basic electronics, but I'm not an RF
engineer. Would anyone care to tell me what I need to do to fix this? I'm
assuming it will take more than just rerouting the tx line to the common
connector...
Thanks helping me dispel a bit of my ignorance :-)
73
Dan
--
K9ZF
Secretary, Clark County Amateur Radio Club,
Amateur Radio Emergency Service, Clark County Indiana.
EM78el
The once and future K9ZF /R no budget Rover
***QRP-l #1269
Check out the Rover Resource Page at:
<http://www.qsl.net/n9rla>
List Administrator for: InHam+grid-loc+ham-books
Ask me how to join the Indiana Ham Mailing list!
---
This email has been checked for viruses by Avast antivirus software.
https://www.avast.com/antivirus
_______________________________________________
VHFcontesting mailing list
VHFcontesting@contesting.com
http://lists.contesting.com/mailman/listinfo/vhfcontesting
|