To: | towertalk@contesting.com |
---|---|
Subject: | Re: [TowerTalk] WX Sensor Placement |
From: | Patrick Greenlee <patrick_g@windstream.net> |
Date: | Sun, 3 Mar 2019 13:18:57 -0600 |
List-post: | <mailto:towertalk@contesting.com> |
Our master suite is ICF construction so there are two layers of 2 1/4
inches of Styrofoam separated by 8 inches of steel reinforced concrete
in the exterior walls. This space can be heated with a candle and
cooled with an ice cube, really well insulated and virtually no
in/exfiltration. yet an RF linked outdoor thermometer within a foot of
the brick veneer reads 5-10 degrees F warmer than when placed 10 ft away
on cold winter night temps. I was surprised at the magnitude of the
variance but the instruments didn't lie.
Wind direction and speed indications are bogus at best if the measuring instruments are mounted in poor locations subject to turbulence. I have seen folks mount anemometers on rooftops and get really erroneous readings. Wind vanes will point somewhere but not necessarily the wind direction away from aerodynamics disturbing impediments. Readings taken downwind of a structure (or trees, etc) need to be taken a minimum of 3 times the widest or tallest dimension of the obstruction from the obstruction and 7 times is better. I know this is not good news for folks on moderate sized lots but you can't just ignore physics because it is inconvenient. Personally, I'd like to be able to suspend gravity on demand but... Patrick NJ5G On 3/3/2019 12:54 PM, George Dubovsky wrote: You pretty much have to avoid the house. As you surmise, even the North side is going to be a heat source or sink. I did not start getting decent readings - ones that compared to Wunderground, etc - until I moved mine to a pagoda (homebrew, made from inverted, stacked dollar-store soup bowls) 75' away from the house. 73, geo - n4ua On Sun, Mar 3, 2019 at 1:38 PM Gedas <w8bya@mchsi.com> wrote:This made me wonder about sensor placement. I have had a number of different wx stations and the instructions most provide for the placement of the outdoor temperature sensor is to simply mount it on the north side of the house just under the eaves. This kind of makes sense as it will be away from direct sunlight but what about the heat from the house? How many do this and does it work for you? Do your temperature readings match those or come very close to an "official" local temp like at an airport. Has anyone else noticed just how critical the placement of this sensor really is? I have 2-3 outside sensors in different locations and they all read differently, sometimes as much as a 4F delta. I made sure they were all calibrated inside the house to read the same then installed them outside. Once the sun goes down my readings stabilize and my readings are within a degree of the "official" airport temperatures. During the day, esp summer time the readings can be all over the place. I know enough to keep them out of the sun, away from objects that can absorb & retain heat, off the ground at least 10' or so, not above concrete, etc......and yet I see big differences. So my question is where and how do people mount their temperature sensors? Also does anyone know where and how the "official" temperature sensors used by the NWS are mounted in places like airports? Gedas, W8BYA Gallery at http://w8bya.com Light travels faster than sound.... This is why some people appear bright until you hear them speak. On 3/3/2019 1:19 PM, Michael Forinash wrote:I bought a Davis Weather Station for my wife, who is a Weatherbird,seven years ago. As I recall, it was a six hundred dollar unit. In the past seven years, the only maintenance I have performed on it is remove a seed (from my neighbor’s tree) that blocks the flow of moisture through its self-emptying range gauge. It has a solar panel that recharges the unit’s rechargeable batteries. I have yet to change them.The unit is attached to a twelve-foot pole. The installation instructions are a little vague on various points, butthat’s the only criticism I can make of this package. Not a cheap station, but one my wife has been happy with, as the base unit sits on a end table by her chair in our living room. She checks the base station five or six times a day when she’s not monitoring the Weather Channel or the ND DOT online.73, Mike KB0RIA_______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk_______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk _______________________________________________ _______________________________________________ TowerTalk mailing list TowerTalk@contesting.com http://lists.contesting.com/mailman/listinfo/towertalk |
<Prev in Thread] | Current Thread | [Next in Thread> |
---|---|---|
|
Previous by Date: | Re: [TowerTalk] WX Sensor Placement, Gedas |
---|---|
Next by Date: | Re: [TowerTalk] WX Sensor Placement, George Dubovsky |
Previous by Thread: | Re: [TowerTalk] WX Sensor Placement, Larry McDavid |
Next by Thread: | Re: [TowerTalk] WX Sensor Placement, n4uu73 |
Indexes: | [Date] [Thread] [Top] [All Lists] |