Towertalk
[Top] [All Lists]

Re: [TowerTalk] Interesting way to install Towers for Power lines

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Interesting way to install Towers for Power lines
From: jimlux <jimlux@earthlink.net>
Date: Tue, 5 Mar 2019 16:11:09 -0800
List-post: <mailto:towertalk@contesting.com>
On 3/5/19 2:06 PM, Jim wrote:
That is REALLY cool!


Thanks
73
Jim W7RY

On 3/4/2019 11:18 AM, Chuck Gooden wrote:

Wonder how they would do on a Rohn tower?

See https://www.youtube.com/watch?v=Z2BeFK6nqMA&feature=share




They'd do just fine on a big stick. The helo lift folks are really impressive. Around here (Los Angeles area) they do this to put big HVAC units on the roof of big buildings when a crane isn't the right tool.

What's really amazing is when they finish the job, and they coil the lifting cable and slings on the ground, disconnect at the helo, and there it is, neatly coiled ready to load back on the truck.

If you had to put a big tower on a hilltop or in a remote location that might be a good way - build it up in a field somewhere with all the antennas on it, pick it up as a unit, fly it, lower it onto a prepositioned set of bolts sticking up, etc.

I've put a remote calibrator transmitter or a precision observation system on a hilltop a couple or three miles away using a helicopter and slings about 20 years ago. As I recall, it cost us about $600 for an hour's helo time. We built the entire station up, set it up with soft slings, they flew over, hovered, dropped a line, we hooked it up and they flew away with it.

Actually, now that I write this, I remember there were two trips with the helo. The first was to carry the installation crew to the hilltop, the second was to carry the transmitter assembly. The crew came back in the helo on the second trip.

I believe the Erickson skycrane in the video runs around $5000-10,000/hr
(OTOH, they can lift a D9 Cat bulldozer, so that's probably overkill for even the most ambitious amateur installation - unless you're going to cast a huge block of concrete, mount the antenna tower on it, and have them haul that up the hill for you)


http://helistream.com/utility/aerial-crane-services-california/
has a picture of them setting wooden utility poles with a smaller helo.

If you were setting up a repeater site in something like a forest fire lookout, helicopter might be the best way to do it- no long approach hike in, they can sling your equipment racks and drop them on a convenient pad on the *top* of the lookout, etc.

It might even be cheaper for something where you've actually got a road up to the site - rather than an hour on twisty dirt roads that wash out, 10 minutes in a helo, and it's a heck of a lot easier if you have that skyhook to hold things up.

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>