Hi All
Went out this morning to crank up the tower to see if I could hear any
of the EU on 6 meters. as soon as it started up I heard a couple
cracking noises. I stopped and tweaked it up and down a little and
discovered that the flange bearing on the back side of the multi wrap
sheave failed.
Anyone with experience replacing this? I was able to retract the tower
to a point that I can block both sections to the base. My thoughts are
to release the tension from the positive pull down end of the cable,
loosen and support the drive assembly so I can swing it out of the way
to get the bearing out. I am assuming I will need to take it to one of
the local bearing shops, unless some one knows what bearing to replace
it with. I know lots of stuff changed over the years at UST and I
purchased this used so don't know the age.
Thanks
Phil
N9LAH
Phil N9LAH
Do you qualify for the WUST Award?
Verify QSO's with 13, 14 or 15 of the US Territories to qualify.
Visit http://www.metrodxclub/wust_award.htm for more info.
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|