Towertalk
[Top] [All Lists]

Re: [TowerTalk] Increasing the Inside diameter of a 1 inch outside diame

To: towertalk@contesting.com
Subject: Re: [TowerTalk] Increasing the Inside diameter of a 1 inch outside diameter Alum pipe.
From: Jim W7RY <jimw7ry@gmail.com>
Reply-to: jimw7ry@gmail.com
Date: Wed, 31 Aug 2022 07:18:13 -0500
List-post: <mailto:towertalk@contesting.com>
?????

DX Engineering has a complete line of aluminum tubing that fits inside of the next smaller or next larger diameter.
73, Jim W7RY


On 8/31/2022 2:40 AM, John Birken wrote:
I need to increase a beam section inside diameter about .06 inch.
The outside diameter of this Al pipe is1 inch.
Mosley was not receiving the element section for a few months.
Amazon had the right Al inch pipe made by an antenna company.
The new  6 foot long section needs to slide in 12 inches to the thinner
section.
The pipes won't slide together because the new pipes ID is a little too
thick
.
Thanks for advice,
John, K2SFS
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
--
Thanks and 73, Jim W7RY
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>