You probably are going to put more stress on the tower by adding the
additional weight and wind load of the extra parts Vs. cutting the brace.
In other words... Cut the brace.
73
Jim W7RY
-----Original Message-----
From: K8RI
Sent: Friday, June 01, 2012 6:17 PM
To: towertalk@contesting.com
Subject: [TowerTalk] Getting your moneys Worth
A while back I mentioned trying to fit a Han IV into a 25G and not
wanting to cut a brace. As the mast will extend about 12' above the top
of the tower, I did not consider mounting inside the short section with
the flat top plate to be desirable either. Sooo... I finally decided to
mount the rotator externally and run a two section mast down through the
tower. That will leave the rotator 20 feet above ground level and 30
feet below the flat top plate...give or take a tad. I should be able to
stand on the roof and work on it.
The rotator will be mounted on a 3/16ths (0.1875" for those working in
decimal) steel plate with a 2" stub mast out the top and through a
thrust bearing. There will be a sprocket on the mast out of the rotator
and another on the mast running up through the tower with bearings
above and below the sprockets. There will be 2 idlers. As this is 80P
chain it's 1" between centers for the rollers. The first digit is the
number of 1/8ths while the second indicates standard (0) chain. Chain
comes in 10' lengths and 10' of 80P just fits in one of the larger "IF
it fits it ships" boxes.
I haven't weighed it but I'd guess that box ran some where between 20
and 30#
BTW, Thanks to all those who came up with suggestions on locations to
find parts that were far cheaper than the big supply houses. 10' of 80P
can run $130 to $140, but through surplus sales in Texas it was (IIRC
$40 shipped to my door) Those sprockets are massive too. Problem now,
other than making the mounting plates for the rotator and bearings is I
have to ream out the ID of the large sprockets to fit the mast which is
2" DOM and the ID of the bearings is 2" for an interference fit. The
idlers just fit over a 3/4" bolt.
I think the top of the tower in
http://www.rogerhalstead.com/ham_files/skyhook.htm is driven by 80P
chain. The sprocket in the second photo from the top appears to be for
80P which looks small in comparison and I'm just using a 2" mast. That
top section is 3 feet across each side.
73
Roger (K8RI)
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|