Amp relay not fully closed before rf? Maybe increase delay by a few
milliseconds?
On Fri, Nov 9, 2018 at 10:04 AM W1JCW John <W1JCW@hotmail.com> wrote:
> Have a strange problem in the shack.
>
> Run the same antennas and had no issues, put in line my Yaesu 5000 and
> palstar AT.
> All antennas tune flat 1:1 but when I run QRO the Acom 2K comes up with
> arc fault even with low drive of 20watts.
>
> I can place a load at the end of the coax outside and have no issues but
> when I got to any antenna 260' center fed dipole or a vertical I get a
> fault and the amp shuts down.
>
> Sounds like an RF issue but why now when nothing has changed outside?
>
> Have not seen anything like this in 40yrs I've been operating.
>
>
> 73-
> W1JCW
> John
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
--
Jim K0XU
jim@rhodesend.net
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|