RigExpert has *All Parameters Mode* when it will display the R, X and the
Resonant Frequency. This is the most useful screen for tuning an antenna.
You can move up and down the frequency to see R and X at different points.
The same screen shows SWR calculated for the impedance set in the settings
of the Rig Expert. You can see it to 25, 50, 75 and 100 Ohm
Alex, WK1O
On Mon, Feb 6, 2023 at 8:55 PM <john@kk9a.com> wrote:
> I have never used a RigExpert analyzer but according to the manual (page 8)
> there is a data screen that will display the various parameters. If you're
> trying to attach only an SWR chart, it's pointless. Does the Hy-Gain
> vertical come with any type of matching device or does the antenna just
> rely
> on high ground losses for low SWR?
>
> John KK9A
>
>
> Test 2019 K7OGW wrote:
>
> Hi Al and all,
> I recently bought a RigExpert AA-230 ZOOM and that's what I measured the
> SWR
> with. I haven't had a chance to figure out, or use the other features yet
> but it's high on my To-Do list. Here's a copy of the attachment that didn't
> make it on TowerTalk. I'm not sure if I can send attachments via TowerTalk.
> Thank you for your replies. I really appreciate it!
> Dennis - K7OGW
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|