Towertalk
[Top] [All Lists]

Re: [TowerTalk] Mast Lifting

To: "TOWERTALK@contesting. com" <TowerTalk@contesting.com>
Subject: Re: [TowerTalk] Mast Lifting
From: Don Moman VE6JY <ve6jy.1@gmail.com>
Date: Sun, 23 May 2021 15:53:49 -0600
List-post: <mailto:towertalk@contesting.com>
If I don't have to lift very far, a suitable turnbuckle works well and can
get in the tiny spaces.  Along that idea, a loadbinder (ratchet type) also
would get it done.

On Sun, May 23, 2021 at 3:30 PM <ed_richardson@shaw.ca> wrote:

> Needing to service the rotator and want to lift the loaded mast up and out
> of the rotator bracket.  I have used a cheap com-along in the past but I am
> now reading that come-alongs are not suitable for lifting and lowering
> loads, they are intended for horizontal movements only.
>
>
>
> A lever hoist would seem to be the appropriate tool.
>
>
>
> So what are the tower experts using for this task? The dead weight would be
> approximately 350 lbs plus any resistance/friction.
>
> Any recommendations?  Safety outweighs cost.
>
>
>
> Ed ve4vt
>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>