They aren't rare and they aren't 8-32 either... not in mine. 6-32's here.
Any old piece of gear that has a terminal strip is is a likely source to
rob one from.... and as others have said, they are easily cut if too long.
On Thu, Jun 29, 2017 at 3:23 PM, Dave Thompson <thompson@mindspring.com>
wrote:
> I have two manuals one as CDE and the last as Hy-Gain (not MFJ). 7 of the
> 8 screws are OK but (stainless Phillips head) but one is a non stainless
> flat head. I went to Ace hardware and the owner knew what type of screw it
> is (8-32 left twist thread) but he says they are rare. I hate to use a
> rusty screw but It looks Ok after spraying with Pre-Lub 6. Does anyone know
> where I can get at least 8 or more flat head stainless screws. The ones Ace
> stocks are too long and he was not sure he could order them.
>
> These are the screws in the terminal strip part 51465-10) that you attach
> the rotor cable or quick connect.
>
> Thanks in advance.
>
> 73 Dave K4JRB
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|