Said to accept maximum of 2 inch OD so has to be a few thousandths over
that. You couldn't even fit a 1.5 inch schedule 40 pipe through it if 1-7/8.
Stan, K5GO
On Wed, May 26, 2021, 9:03 AM CEPitts <cpitts@ec.rr.com> wrote:
> Hi Mark my small metal caliper measures at 1 and 7/8" or 27mm....if it is
> off it only by 1mm according to my handy little caliper. If others respond
> hopefully they confirm what I have provided. Charle4s "Ed" K5OF in NC
>
> Hello group!
>
> Could someone here give me the precise inside diameter of this bearing?
> Quick
> checks in the Rohn catalog (over 230 pages) I was unable to find it.
>
> Thanks!
>
> Regards,
>
> Mark, K1RX
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|