Towertalk
[Top] [All Lists]

Re: [TowerTalk] Cushcraft 40-2CD skywalker

To: Untitled <towertalk@contesting.com>
Subject: Re: [TowerTalk] Cushcraft 40-2CD skywalker
From: Mike Fatchett W0MU <w0mu@w0mu.com>
Date: Thu, 06 Dec 2007 15:14:15 -0700
List-post: <mailto:towertalk@contesting.com>
I have a 40-2CD that has been up well over 15 years at my folks house, which
I need to take down, that was never strengthened and has survived all of
those winters and wind.

I am pretty sure I crushed the ends of the boom though.

Still the best 40m beam for the bux....IMHO


On 12/6/07 12:46 PM, "Dick Green WC1M" <wc1m@msn.com> wrote:

> Roger,
> 
> The primary mod is to strengthen the boom and elements.
> 
> Try this link: http://www.qsl.net/k7vc/402cd.html. It's an article by Dave
> Leeson, W6QHS, on strengthening the 40-2CD. It's pretty extensive. I believe
> there's another article detailing a subset of Dave's modifications that
> appeared in the ARRL's National Contest Journal, but offhand I don't know
> the date or author. My 40-2CD, which I also purchased second-hand, was quite
> old (#5 or #6 off the production line) and the elements had drooped
> significantly. I replaced the tubing in and near the center of each element,
> and reinforced it per the article in NCJ.
> 
> You should check the coils and their screws to make sure they're in good
> condition. Replacements can be ordered from Cushcraft or you can fabricate
> your own.
> 
> 73, Dick WC1M
> 
>> -----Original Message-----
>> From: Roger Cooke [mailto:g3ldi@yahoo.co.uk]
>> Sent: Thursday, December 06, 2007 9:54 AM
>> To: towertalk@contesting.com
>> Subject: [TowerTalk] Cushcraft 40-2CD skywalker
>> 
>> Hi.
>> 
>>   I have just obtained a second hand one of these and I think I have
>> missed
>> out on some mails regarding this antenna. Are there any mods to do
>> before
>> putting it up? I am not sure what condition it is in as it has been
>> stored for
>> a number of years, but it should not have suffered too much.
>> 
>> Any comments or suggestions appreciated.  I am thinking of using
>> a Pro-Sis-Tel P-61 rotor as it is not too heavy.
>> 
>> 
>> 73 de Roger, G3LDI
>> 
>> 
>> Regards from Roger, G3LDI
>> Swardeston, Norfolk.
>> 
>> 
>> ---------------------------------
>>  Sent from Yahoo! &#45; the World&#39;s favourite mail.
> 
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk


_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>