Sorry guys. The file was supposed to go to Larry only.
73 Bert, VE3NR
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Larry Banks
Sent: Wednesday, August 01, 2012 9:30 PM
To: Tower Talk
Subject: [TowerTalk] Rotator Mounting Dimensions
Hi TT'ers
I am designing a base plate for mounting an old TR-44 rotator and cannot
find dimensions anywhere on the Internet. I measure 3" c-to-c from the
rotator on my workbench. Is this the correct dimension? What size hole?
Is this the same for modern Hy Gain rotators too?
(Since I may purchase a new rotator in the future if this one fails, I am
also going to add holes for Yaesu rotators -- at least I know that the
correct dimension there is 84mm for all of them.)
73 -- Larry -- W1DYJ
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|