Is it important or helpful to fill the control cable connector that plugs
into the rotator with dielectric gel (such as Dow Corning) to prevent water
intrusion?
I understand that if I ever had to repair the soldered connectors inside
(extremely unlikely) that the goop would be a pain. But other than that, is
there any downside? Or is it complete overkill?
Rotator is Yaesu G-1000DXA but I would think this question applies to any
rotator connector.
Thanks in advance,
73,
Michael - N6MEF
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|