Another alternative:
Drill about a 5/16 inch through hole in the PVC about 1/2 to 1 inch down from
the end and then cut a slot about the width of the wire diameter between the
top of the holes and the top of the PVC. Snap the wire through the slots into
the hole. Wire will slide, will not come out and can be removed if needed.
73...Stan, K5GO
Sent from my iPad
> On Jan 31, 2015, at 11:13 AM, Jim Brown <jim@audiosystemsgroup.com> wrote:
>
>> On Sat,1/31/2015 3:16 AM, Patrick Greenlee wrote:
>> This PVC pipe over T posts sounds like a workable solution.
>
> That's pretty common out here in California -- someone showed it to me, and
> I'm using quite successfully both for Beverages and to elevate radials. I cut
> the steel to about 4 ft, stick it in the ground, drill a hole through the top
> of the PVC, slide the pipe over the steel, and ty-wrap the wire to the pipe
> through the hole.
>
> 73, Jim K9YC
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|