In 2016....
I fell a 110 foot Rohn 25 with 2 TH6, and a shorty 40.
Removed one entire side of 3 guy wires. I could not believe the 25 kept
standing with all that pull of the other 2 sets of guys!
Then I cut the leg the guys that I removed were attached to. I had to
cut most of the way through it.
It fell right down. Saved all but one section. A friend picked up what
was left of the 2 TH6s and the old shorty 40.
Oh.... The 21 foot schedule 80 (water pipe) mast also bent right at the
thrust bearing.
73, Jim W7RY
On 9/21/2024 10:52 AM, pwhelton@earthlink.net wrote:
Have you considered dynamite?
Pat - KZ5J
-----Original Message-----
From: TowerTalk <towertalk-bounces@contesting.com> On Behalf Of cqtestk4xs---
via TowerTalk
Sent: Saturday, September 21, 2024 9:19 AM
To: towertalk@contesting.com
Subject: [TowerTalk] DROPPING A TOWER
In a few weeks I will be taking down a 136 ft Rohn 55 tower with its base set
in concrete. I won't be taking it down section by section, but rather dropping
the whole thing.
I have some pre-conceived ides as to how to do it, but have never done it
beiore. No issues with power lines or neighbor's property...noner are an
issue. Lots of cleared space folr the tower to be dropped.
Any ideas or suggestions would be greatly appreciated.
Bill K4XS/V31XX
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
--
Thanks and 73, Jim W7RY
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|