Has same behavior on dummy load?
Try getting rid of all coax switches, surge suppressors, anything in the RF
path to antenna, then swap out jumper cables & connectors. I am thinking
cable/connector issues in the RF path. It's possible the issues are not even
located very near the tuner.
A puzzler for sure.
GL 73
dan
k0dan
-----Original Message-----
From: Tom Osborne
Sent: January 01, 2015 22:00
To: towertalk@contesting.com
Subject: Re: [TowerTalk] Tuner SWR won't stay down
Hi Bob
No, it matches the antenna just fine. SWR goes to zero. Then it starts
to creep up after a few seconds. Then I can re-tune it back to zero
again, but doesn't stay there. Thanks and 73
Tom
On 1/1/2015 12:30 PM, W3YY wrote:
The other tuner worked and your new MFJ didn't. Sounds like whatever you
are trying to match is outside the range of the MFJ, but OK with the other
tuner you put in line. Without further data, that's my initial
impression.
GL.
73, Bob - W3YY
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|