I've got a T2X recently acquired used that has a terminal strip on the bottom
badly corroded from exposure, to the point where 4 of the 8 screws are rusted
frozen solid and will not budge despite WD-40, screwdrivers, and a lot of
begging on my part :-)
Assuming I can get the screws on each side of the terminal strip loose (which I
have not tried yet), is there enough slack with internal wiring to take those
screws out, pull the terminal strip up and out without actually going in and
opening up the housing of the rotator? Or am I going to have to pull it open?
I can't really tell from looking at the pics in the manual. In any case, this
part is going to definitely need replacing...
Thanks in advance,
Scott W4PA
____________________________________________________________________________________
Be a better friend, newshound, and
know-it-all with Yahoo! Mobile. Try it now.
http://mobile.yahoo.com/;_ylt=Ahu06i62sR8HDtDypao8Wcj9tAcJ
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|