Towertalk
[Top] [All Lists]

Re: [TowerTalk] Mast slippage

To: "towertalk@contesting.com" <towertalk@contesting.com>
Subject: Re: [TowerTalk] Mast slippage
From: "Lee K. Brown MD via TowerTalk" <towertalk@contesting.com>
Reply-to: "Lee K. Brown MD" <lkbrownmd@cs.com>
Date: Wed, 29 Jul 2020 01:04:13 +0000 (UTC)
List-post: <mailto:towertalk@contesting.com>
Been there, done that (with a Yaesu G-2800DXA). Not easy, but definitely 
possible. Prepare for a long stay up there; be patient. Bring a spare battery 
for your cordless drill, or use a real drill that you plug into an AC outlet 
with a loooong extension cord. Unless you have a really steady hand, you will 
unavoidably widen the hole you start at if it's a Yaesu aluminum mast bracket.
Lee, KI7UR

Lee K. Brown MD
Professor of Internal Medicine 
Department of Internal MedicineProfessor of PediatricsUniversity of New Mexico 
School of Medicine
Professor of Electrical and Computer Engineering
University of New Mexico School of Engineering
Albuquerque, NM

-----Original Message-----
From: Kim Elmore <cw_de_n5op@sbcglobal.net>
To: Les Brown <lesbrown@sympatico.ca>
Cc: towertalk@contesting.com
Sent: Tue, Jul 28, 2020 6:50 pm
Subject: Re: [TowerTalk] Mast slippage

This will be challenging. You need very hard bits (real cobalt bits, not just 
the gold colored ones), plenty of cutting oil, patience (because you’ll have to 
go slow), and lots of stamina (because as you go slow you’ll have to apply lots 
of pressure). 

Kim N5OP

"People that make music together cannot be enemies, at least as long as the 
music lasts." -- Paul Hindemith

> On Jul 28, 2020, at 6:06 PM, Les Brown <lesbrown@sympatico.ca> wrote:
> 
> I have 2 large Yagis attached to a 3 inch OD ¼ inch wall thickness Chromoly
> mast running down the tower to a ProSisTel PST-71D. On a windy day, I hear
> creaking sounds from the tower. The mast is slipping slightly in the rotator
> mast bracket. I’ve already tried to tighten the 6 bolts, but it still slips.
> I don’t want to tighten them to the point where they might snap. I’m
> thinking that what I need to do is to go up the tower, drill a hole through
> the mast (the rotator mast bracket already has holes), and pin the mast and
> bracket. I understand that it’s not easy drilling through Chromoly pipe, so
> before I try this, I thought I would ask if any of you have any other
> suggestions.
> 
> 73, Les VE3NNT
> 
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
<Prev in Thread] Current Thread [Next in Thread>