I too, have gone greater than 80% to allow the antennas on the rotating tower
to clear the guy wires. Currently the top guys on my tower are at 84 feet and
are pulled out to around 100 feet. Realize though, that the tower is now
pulling more sideways and less downward than before when it was at 84 feet. I
believe that taken to extremes this would eventually allow the tower to pull
apart in heavy wind, especially if it was Rohn 25. I have done the height
equals guying distance on 200 footers and have had no issues. However, they
were never tested in a hurricane, so who knows?
Bill KH7XS/K4XS
-----Original Message-----
From: Bob Shohet, KQ2M <kq2m@kq2m.com>
To: cqtestk4xs <cqtestk4xs@aol.com>; towertalk <towertalk@contesting.com>;
Grant Saviers <grants2@pacbell.net>
Sent: Wed, Dec 5, 2018 4:54 pm
Subject: Re: [TowerTalk] guying distance
For various terrain and property line related reasons I have had to go shorter
than and significantly longer than the 80% with specific legs of my two towers,
as short as 65% and as long as 130%. This also has an effect on the tensioning
of the guy wires – and which needs to be taken into account. What is often not
realized until after the fact is that if your intention is to stack multiple
antennas and rotate them separately, either on sidemounts or ring rotors, using
less than ~ 80% may compromise or eliminate your ability to stack and rotate
the “in-between” antennas because they will likely get caught in the guy wires.
And, if there is not enough extra clearance, even if you can safely rotate
under the guy wires on a calm day, on a day when it is windy or icy or both,
you might not clear those same guy wires! It is quite remarkable to see just
how much those guy wires can move and bounce around in violent T-storm or
worse! Depending on the band, length of the boom and elements, proposed height
of the antenna, heights of the guy wire attachment points and proximity to the
antenna, radius of antenna (mounted on the rotator) from the tower legs
(especially if side-mounted) and other factors, 80% may not be enough either;
but it will at least get you “in the ballpark” and give you some viable
options. 73 Bob KQ2M From: Grant Saviers Sent: Wednesday, December 05, 2018
11:17 AMTo: cqtestk4xs@aol.com ; towertalk@contesting.com Subject: Re:
[TowerTalk] guying distance Except that a PE can change this with the proper
analysis. Also, a post
plus deadman end is a way to geometrically shorten the 80%. Look at
commercial guyed towers and they often have a shorter guy anchor to base
perecent (ie steeper guy angles).
Grant KZ1W
On 12/5/2018 7:42 AM, Bill via TowerTalk wrote:
> Rohn specifies 80% of the height for their towers..25, 45, 55, 65 all the
> same.
> Bill K4XS/KH7XS
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|