DX Eng provides good hardware and aluminum, but not providing schematics
is a REAL problem. My 4 sq receive is now useless with an intermittent
noise problem. Also, workmanship for an outdoor product was poor, flux
left on boards, solder spatter on inductors, and lots of on he board
gunk growth/corrosion after 2 years - the boards should be conformal
coated. I think this is originally a W8JI design, and when it worked it
was great. Not so now.
K3LR are you listening?
Grant KZ1W
On 9/5/2015 9:24 AM, Jim Brown wrote:
On Sat,9/5/2015 8:46 AM, Michael Murphy wrote:
I will also weigh in as well.
I'm not as thrilled with DXE as those who have posted in this thread.
I like to work on my own gear, and DXE makes that difficult by not
providing a schematic for their products. About 8 years ago, I bought
and installed two reversible Beverages using their hardware for the
Beverages and for switching. A few years later, I had to troubleshoot
an issue with that system, and the lack of schematics made it MUCH
harder than it should have been. For that reason, I've been avoiding
them.
73, Jim K9YC
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|