Cecil Moore wrote:
> I brought six ten-foot sections of Rohn 25G with me from AZ to TX when I
> retired.
> I intended to put up a 60 foot tower. But one of the sections has 11"
> spacing on
> the top instead of the 11.25" specified spacing. Does anyone know where this
> 11"
> spacing came from? Are sections of 25G available with 11" spacing between
> the
> mounting posts? This has bothered me for years. The bottom post spacing is
> the
> correct 11.25" spacing so this one section would not fit into an identical
> section
> like itself.
> --
> 73, Cecil, w5dxp.com
Most likely you'll find that one or more of the legs have been bent in
at the top. If this is a new section (never installed) then there's a
chance it was a manufacturing defect. I have run into new tower
sections that were this far out before, though never with Rohn towers.
Ethan KC8HES
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|