jacobsen_5@msn.com wrote:
> Mark said:
>
> "There seem to be 2 obvious options given I'll be using an Alliance HD73
> and a 12' 6061-T6 mast, 2" OD x 1/4" wall. (Yes, I've done load calcs to
> make sure it will not break"
>
> Hi Mark, I would seriously think about getting a different rotor that will
> handle the load. I would be real concerned that the HD73 would handle a T8 or
> T11, plus other aluminum. You could end up with a nice windmill up there.
>
> Just my $.02
>
> 73
> Good luck with your project.
>
> K9WN Jake
I'll ditto that from family experience.
My father had an HD-73 turning a Cushcraft A4 and an 11 el Hygain 2m
beam 5 ft above the A4. If you believe the HD-73 specs this load
shouldn't have been a problem as both beams and mast were about 65% of
the rated rotator windload.
The rotator lasted about 2 years.
R. Kevin Stover
ACØH
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|