Hello TT,
I'm in need of the bolt patterns for the G800S & Tailtwister rotators. I'm
fabricating rotator shelves for these rotators for someone else & I would
like to know where to bore the holes, relative to each other, on the plate.
I know the Ham II/IV series is on 3" centers, is the Tailtwister the same?
I do not have either of these rotators. Any useful information is very much
appreciated.
73,
Robin E. Midgett KB4IDC EM66se
rmidgett@bellsouth.net
1/2 of the Award Winning NT4L Rover Team
http://kq4tv.aprs.net/vhf/vhf.html
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|