After reading quite complementary comments in ON4UN's latest edition of
"Low Band DXing", I decided to investigate MFJ's model 1026 "Noise
Canceling Signal Enhancer", a phase shifting circuit for receiving
antennas. I downloaded the manual from the MFJ web site and it contains a
couple provocative statements.
It says to ground the box with solid copper wire. "Woven or braided wire
has higher RF resistance than solid connectors". Is this true? I thought
the skin effect made braid a better conductor of RF at HF frequencies. Am
I misinformed?
At another point the author writes:
"Adequate lightening protection can be obtained by burying coaxial
feedlines directly in the ground for 20 feet (or more) before the feedline
enters the building. In addition, the feedline's shield should be grounded
to the station ground at the point where the feedline enters the
building. ... In-line coaxial lightning arrestors offer minimal
improvement in lightning protection The best method of protecting station
equipment is to disconnect the feedline outside the building during
threatening weather or when the station is not in use"
So how does burying the feedline work? Wouldn't that mean the transient
would blow a hole through both the dielectric and the outside
covering? And advice to disconnect your station sounds like
impractical. I have a job, a wife, and lots of interests in life. I can't
sit around looking for threatening weather? And nobody disconnects the
telephone systems during a storm.
But this box sounds like it would have lots of uses on the low bands. I
think I am going to get one.
Wes, WZ7I
List Sponsored by AN Wireless: AN Wireless handles Rohn tower systems,
Trylon Titan towers, coax, hardline and more. Also check out our self
supporting towers up to 100 feet for under $1500!! http://www.anwireless.com
-----
FAQ on WWW: http://www.contesting.com/FAQ/towertalk
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
|