Ummmmmmmmmmmmm
<SNIP>
You might try loosening the Yagi mounting clamps and let them slide down
the mast to the top of the tower. Then slide the mast up using a gin pole
until you can insert the bearing. Then let the mast down and re-mount the
beams. I think you will be much happier with a proper bearing.
<Snip>
Let's think about that........ You slide the yagi down to the top of the tower.
Then raise the mast to insert the new bearing.
This would mean the mast AND yagi would be above the top of the tower. What
would support the mast and yagi while the mast is out of the tower??? Nope,
don't think so.
I like the idea of raising the mast out of the rotor just enough so you can
place the bearing on the bottom of top plate. It would be easier to keep the
mast braced vertical while doing it.... not to mention stable.
Just my $.02 worth.
K9WN Jake
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|