I take mine and wrap the copper around the ground rod and the cut a slit in
the top and bottom with a hack saw and then use hose clamps.
73,
Dave N0EOP
-----Original Message-----
From: Gary K9GS
Sent: Sunday, October 13, 2013 7:01 PM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] Connecting Flat Copper to 5/8" Ground Rod
I highlu recommens KF7P Metalworks.
http://www.kf7p.com/KF7P/GroundRodClamps.html
I just ordered some ground rod clamps last week. They are at my office
so I haven't seem them yet but if the quality is anything like the
customer service they will be great.
On 10/13/2013 4:47 PM, Ray Benny wrote:
Has anyone come up with a way to connect flat copper straps to ground
rods?
DXXE sells copper clamps w/ hardware, but at $35 a pop, I hoping that
there
is a more reasonable way to get the job done.
My copper strap is 2" wide, by 6ft, and about 18 ga, but not sure.
Tnx,
Ray,
N6VR
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
--
73,
Gary K9GS
Greater Milwaukee DX Association: http://www.gmdxa.org
Society of Midwest Contesters: http://www.w9smc.com
CW Ops #1032 http://www.cwops.org
************************************************
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|