>Hi Folks,
>
>The thimbles I got from Texas Towers and Hill Radio come down to a narrow gap,
>too small for the thimble to slip over a turnbuckle or shackle. I need a
>practical idea for increasing the gap from around 3/16" to 7/16". The 3/8"
>thimbles are made of thick metal and are extremely stiff.
>
>Regards,
>Pete
>KS4XG
>
>(Hill Radio came through with my special order of Rohn parts. I'm very
>satisfied with their prices and service.)
I found the easiest way to deal with that problem is to clamp one side of
the thimble in my bench vise and bend the other side away from it with a
pair of pliers. This opens the jaws up "sideways" and you close them the
same way after the turnbuckle is installed. You can then squeeze the
thimble jaws a little tighter by rotating the thimble 90 degrees in the vise
and closing the vise on them. Sometimes a little of the galvanizing flakes
off in this operation but I have never regarded that as a significant problem.
Stan w7ni@teleport.com
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search.htm
|