Towertalk
[Top] [All Lists]

Re: [TowerTalk] Beverage on Ground: 50 ohm or 75 ohm system?

To: "john@kk9a.com" <john@kk9a.com>
Subject: Re: [TowerTalk] Beverage on Ground: 50 ohm or 75 ohm system?
From: Kim Elmore <cw_de_n5op@sbcglobal.net>
Date: Wed, 24 Jan 2018 09:09:45 -0600
List-post: <mailto:towertalk@contesting.com>
I have K9AY loops and LOTS of deer. I tie small clot strips on the bottom wire. 
No problems. 

Kim N5OP

"People that make music together cannot be enemies, at least as long as the 
music lasts." -- Paul Hindemith

> On Jan 24, 2018, at 07:41, "john@kk9a.com" <john@kk9a.com> wrote:
> 
> I use 50 ohm coax for all RX antennas (Beverages, Pennants, etc). I either
> use old Heliax or RG8X and use mostly UHF connectors. I guess 75 ohm and F
> connectors are popular because of pricing but 50 ohm works perfectly. BTW
> I have a lot of deer and they seem to be good at avoiding my temporary
> Beverages.
> 
> John KK9A
> 
> 
> 
> To:    Towertalk
> Date:    Wed, 24 Jan 2018 06:47:17 -0600
> 
> I'm working on installing my first 160 receive array.
> 
> I don't have room for traditional beverages.  Ground mounted receive loops
> like the K9AY array will not be a good solution as I have a large deer
> population that would end up tearing it down.  We had an 8 point buck with
> xmas lights hanging off his antlers so I don't think loops would survive
> 
> As I go through the design I'm trying to determine if I should use a 75
> ohm system (the most common due to cheap rg-6 coax I suppose) or a 50 ohm
> system.  I have plenty of rg-8x coax laying around and I could use a
> remote coax switch to get all of the signals (4) from two reversible
> Beverage on Ground (BOG) arrays.  I would prefer to bring in a single coax
> to the shack vs 4 separate lines.
> 
> Will a 50 ohm system play well with the available pre-amps.  All of the
> pre-amps I have found have F-connectors which leads me to believe they are
> setup for 75 ohms.  If I go with RG-8x/50ohm matching transformers do I
> need to consider a 50 to 75 ohm transformer before going into the pre-amp?
> 
> What about the output of the pre-amp into the 50 ohm input of the receiver?
> 
> Thanks in advance.
> 
> Rich - N5ZC
> 
> _______________________________________________
> 
> 
> 
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>