Well, my tower guy cable clamps are sufficiently rusted to warrant
changing them out--I may be a couple of years too late, actually, but....
What's the recommended procedure?
Should I simply remove one and put a new one in it's place, one at a
time?
Or should I place offset the new ones, then take the old ones off?
If I need to take up some slack in a guy, what should I do about the
crimps in the guy, since they would now by offset by a few inches or
more?
Or should I just ignore them and place the clamps at appropriate
distances from the loop?
e-mail me directly and I will summarize to the reflector.
Thanks in advance...
73,
Dale Martin, KG5U
kg5u@hal-pc.org
http://www.hal-pc.org/~kg5u
--
FAQ on WWW: http://www.contesting.com/towertalkfaq.html
Submissions: towertalk@contesting.com
Administrative requests: towertalk-REQUEST@contesting.com
Problems: owner-towertalk@contesting.com
Search: http://www.contesting.com/km9p/search
|