The correct dimension for a 45AG4 flat top section is 3 1/16" as it is used
for the TB3 and TB4 thrust bearings.
Carl
KM1H
----- Original Message -----
From: "John Kjos" <john@w9rpm.com>
To: "TOWERTALK" <towertalk@contesting.com>
Sent: Tuesday, July 10, 2007 1:28 PM
Subject: [TowerTalk] Rohn 45
> HI, Could someone tell me the OD of the hole for the mast in a Rohn 45 Top
> Plate? Thanks- john
> EMAIL: john@w9rpm.com
> WEBPAGE: http://www.w9rpm.com/
> AOL IM: W9RPM
>
>
>
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|