I lost a few ball bearings under similar circumstances and managed to buy
replacements at the Orchard Supply store believe it or not, which saved my
Sunday.
Mike, K6BR
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of
> Larry K3VX
It's not too difficult, but it is tedious. When you open it, do it in or
in/over a box or tub, else you'll be chasing ball bearings til the code
requirement comes back.
73,
Mike NF4L
_______________________________________________
That reminds me of the time I opened up a HamM rotor on top of a roof (back
in the early 70s), not knowing what was inside. I soon found out....about
a
hundred or so greasy bearings that rolled down the tile roof in a clatter
and
off into the tall grass, never to be found. All other rotors have been
opened up on the bench since then!
Bill KH7XS/K4XS
**************Make your life easier with all your friends, email, and
favorite sites in one place. Try it now.
(http://www.aol.com/?optin=new-dp&icid=aolcom40vanity&ncid=emlcntaolcom00000
010)
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
No virus found in this incoming message.
Checked by AVG - http://www.avg.com
Version: 8.0.176 / Virus Database: 270.9.14/1832 - Release Date: 12/5/2008
9:57 AM
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|