Towertalk
[Top] [All Lists]

Re: [TowerTalk] TOWER MAST - WHAT DO YOU THINK IS BEST

To: "'Michael Mark, P.Eng.'" <m2eng@mts.net>,<towertalk@contesting.com>
Subject: Re: [TowerTalk] TOWER MAST - WHAT DO YOU THINK IS BEST
From: "JC Smith" <jc-smith@comcast.net>
Date: Fri, 25 Aug 2006 10:26:57 -0700
List-post: <mailto:towertalk@contesting.com>
Forget EMT, forget stainless steel (unless you really need stainless for
some reason).  Aluminum would be ok, but do the math. Check your wind load
and be sure the aluminum will handle it.  Most long, strong masts are .250
wall, galvanized 4130 Chrom-Moly steel.  .250 wall, galvanized 1026 DOM
(Drawn Over Mandrel) is also popular but not as strong.  If you are just
putting a little tribander a foot above the thrust bearing you could even
use galvanized pipe.  You actually have a lot of choices but you need to
figure out what strength you need and go from there.

What will be your configuration (antenna wind area and height above the
tower)?

73 - JC, K0HPS

-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com]On Behalf Of Michael Mark, P.Eng.
Sent: Thursday, August 24, 2006 10:33 AM
To: towertalk@contesting.com
Subject: [TowerTalk] TOWER MAST - WHAT DO YOU THINK IS BEST

I am installing a beam on a tower and am wondereing what you think is best
for a 2" O.D. Mast.

1/4" wall Aluminum

Stainless Steel

Galvanized

Electrical EMT is measured in I.D. not O.D. so that is a problem for 2" O.D.
because 2" EMT is more than 2" O.D.

73

Mike, VE4MM
_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>