Towertalk
[Top] [All Lists]

Re: [TowerTalk] Loosing guy wires when hoisting antenna

To: <towertalk@contesting.com>
Subject: Re: [TowerTalk] Loosing guy wires when hoisting antenna
From: <john@kk9a.com>
Date: Sat, 20 Feb 2021 16:10:39 -0500
List-post: <mailto:towertalk@contesting.com>
I previously responded to the guy wire removal part of the question but Dan
is right about traming higher to clear the guy. It can even be done without
a tram and without removing guys. I have installed many large antennas in
the middle of a tower by having the pull rope pulley near the top of the
tower and just pulling the antenna away around the guys as it is raised.

John KK9A 


K1TO wrote:

Forget the guy wire complications.  Tram to a higher spot, say 70'
nominally, then it is relatively trivial to drop the antenna into place.
73, Dan
 

I am hoisting JK Mid Tri (100 lb) to 65' on a 100' 45G. There are 3 sets of
guy wires at 32', 62' and 95'. I am not clearing one guy at 62'. If I
remove that guy wire, should I loosen the other guy wires at 62', to avoid
potential bending?

Ignacy NO9E

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>