As far as normal ground resistance I'd really not expect to see much
difference. OTOH I'd be concerned about diode action and noise from the
barbs in some conditions. The barbs are just a short piece of wire pointed
on both ends that is wound between the two main steel strands. The only
thing holding the barb is the twist plus a slight kink in the barb itself.
One other thing. I'd sure hate to catch one with the lawn mower. IF it
didn't get you while winding it up it'd still be a lot of fun getting out
from under the mower deck. <:-)) OTOH, steel electric fence wire is
relatively inexpensive and I'd bet it'd do a pretty good job even if it had
to be replaced every few years in some locations.
Roger Halstead (K8RI and ARRL 40 year Life Member)
N833R - World's oldest Debonair CD-2
www.rogerhalstead.com (Use return address from home page)
>
>
> Don said:
>>that had switched to using barbed wire fence material for ground radials <
> How much more loss is one likely to get from using galvanised wire for
> radials?
> My feeling is 'not much', and probably not measurable in an amateur
> context. But what do others think?
> 73
> Peter G3RZP
> PS I think that this is back on antennas
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
>
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|