My foldover tower is guyed in 4 directions at two levels. I use 1/4 in SS wire
rope and cut all 8 pieces using the Dremel cutoff discs. Go easy as the cutoff
materiel is quite brittle. WEAR EYE PROTECTION.
Ron N9AU
-----Original Message-----
From: TowerTalk <towertalk-bounces@contesting.com> On Behalf Of Richard
Blumenstein
Sent: Monday, June 29, 2020 2:22 PM
To: towertalk@contesting.com
Subject: Re: [TowerTalk] How best to cut 1/4 inch ss cable?
Phil-
I never tried it on ss cable, but if you have a Dremel tool, try cutting it
with one of their very thin cutoff wheels. I have a feeling that might work. I
have easily cut off 1/8" nails coming out of a board whose other side I could
not get to in order to remove it.
Dick, K0CAT
=================================
Phil wrote on 6/27/2020 3:08 PM:
> Any recommendations? I was thinking about taping the place for the
> cut with electrical tape and then wedging it in a piece of copper
> tubing....
>
> thanks, 73, Phil W5BVB
> _______________________________________________
>
>
>
> _______________________________________________
> TowerTalk mailing list
> TowerTalk@contesting.com
> http://lists.contesting.com/mailman/listinfo/towertalk
//
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
--
This email has been checked for viruses by AVG.
https://www.avg.com
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|