You might find this article helpful:
http://www.kg4jjh.com/pdf/Antenna%20Rotator%20Controller.pdf
Dick, K6KR
-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Jim Miller
Sent: Tuesday, September 20, 2011 3:22 PM
To: TowerTalk@contesting.com
Subject: [TowerTalk] Channel master operation?
I've got a Channel Master to rotate my Hexbeam. It has only three wires that
control it. Anyone know how this functions to turn and indicate direction
with only three wires?
It has a wallwart that provides power to the control unit that is 18VAC
output. Any idea of the signal levels on the lines? I was going to buy some
TVS diodes for protection but want to make sure I get ones with proper
breakdown voltage.
I can always tear it down myself and scope it out but it would be nice to
avoid if someone had already done so.
Thanks!
Jim ab3cv
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
_______________________________________________
_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk
|