Towertalk
[Top] [All Lists]

Re: [TowerTalk] Protecting Buried Guy Anchors and Tower Sections

To: "'Mark Robinson'" <markrob@mindspring.com>, "'Ro Grrr'" <rogrrr@hotmail.com>, <TowerTalk@contesting.com>
Subject: Re: [TowerTalk] Protecting Buried Guy Anchors and Tower Sections
From: "Michael Ryan" <mryan001@tampabay.rr.com>
Date: Thu, 14 Oct 2010 10:42:00 -0400
List-post: <towertalk@contesting.com">mailto:towertalk@contesting.com>
Oil might seem like a good idea INSIDE the legs, but if it gets outside the
legs and it would seem very easy for it to weep out a joint someplace, over
time this could make for a nasty, greasy, then dirty climb. Not sure that is
something I would consider. Hold on tight...  - Mike

-----Original Message-----
From: towertalk-bounces@contesting.com
[mailto:towertalk-bounces@contesting.com] On Behalf Of Mark Robinson
Sent: Thursday, October 14, 2010 9:17 AM
To: Ro Grrr; TowerTalk@contesting.com
Subject: [TowerTalk] Protecting Buried Guy Anchors and Tower Sections

A product like Waxoyl would be good too.


I wanted to pour oil down inside the legs of my 86 foot Rohn 45 which is 
buried in concrete.  What is the best way to do this? Will it be possible to

get one of the tower bolts out to do this or is this impossible with all the

weight on the lower sections now





Mark N1UK
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
>>>>>

> OK, How about pouring used motor oil onto the steel where it comes out of 
> either the concrete or out of the dirt ?
> I've never seen steel rust/corrode/galvanize if it's coated with oil.
>
> And you can also consider BOILED LINSEED OIL.
>
> After all, BOILED LINSEED OIL is THE main ingredient in ZIEBART !
>
> RoGrrr
> KC8HZ
>
> >>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>

> Absolutely not. Increasing the pH could make the problem worse. The issue 
> is that while there is sufficient galvanizing applied to tower components 
> to protect them in air, this amount of zinc can be uickly used up when 
> buried underground.
>
> I would direct you to review an article in the current issue of QST, "Is 
> Your Tower Still Safe", by yours truly. It will explain the problem; how 
> to do an inspection, and what to do to control corrosion fter the zinc is 
> gone.
>
> 73,
>
> Tony, K1KP

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
>>>

>
> >Would it be a good idea to protect against this by applying lime at 
> >regular intervals around the guy anchor to increase the
> soil ph?
>
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
>>>>>>>>

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

__________ Information from ESET NOD32 Antivirus, version of virus signature
database 5531 (20101014) __________

The message was checked by ESET NOD32 Antivirus.

http://www.eset.com


 

__________ Information from ESET NOD32 Antivirus, version of virus signature
database 5531 (20101014) __________

The message was checked by ESET NOD32 Antivirus.

http://www.eset.com
 
 

__________ Information from ESET NOD32 Antivirus, version of virus signature
database 5531 (20101014) __________

The message was checked by ESET NOD32 Antivirus.

http://www.eset.com
 

_______________________________________________



_______________________________________________
TowerTalk mailing list
TowerTalk@contesting.com
http://lists.contesting.com/mailman/listinfo/towertalk

<Prev in Thread] Current Thread [Next in Thread>